X25AM Management Programming Manual

Common Definitions
X25AM Management Programming Manual—528037-001
5-3
SPI Standard Definitions
All SPI standard definitions are fully described in the SPI Programming Manual.
Information about these definitions that is specific to the X25AM subsystem is given
below.
ZSPI-SSN-ZX25
is the subsystem number assigned to the X25AM subsystem.
ZSPI-TKN-COMMAND
contains the command number of an X25AM command. These command numbers
and their associated commands are described in Section 6, Commands and
Responses.
ZSPI-TKN-MANAGER
contains the name of an X25AM line. This token must be present in a command if
SCP would be unable to determine from the object name alone which object is to
be affected by the command. If the object name is enough information for SCP, this
token is not required.
ZSPI-TKN-OBJECT-TYPE
contains the object-type number of an X25AM object. These object-type numbers
are described under Data Communications Standard Definitions on page 5-5.
ZSPI-TKN-RETCODE
is the return token, which contains one of the X25AM or common data
communications error numbers. For descriptions of all X25AM error numbers, see
Appendix A, Error Numbers and Error Lists.
For descriptions of all common data communications error numbers, see the SPI
Common Extensions Manual.
ZSPI-TKN-SERVER-BANNER
contains the server-banner string for the X25AM subsystem.
ZSPI-DDL-ENUM
ZSPI-DDL-FNAME
ZSPI-DDL-FNAME32
ZSPI-DDL-INT
ZSPI-DDL-INT-PAIR
ZSPI-DDL-INT2
ZSPI-DDL-TIMESTAMP
ZSPI-DDL-UINT
Table 5-1. SPI Standard Definitions Used by the X25AM Subsystem (page 2 of 2)