X25AM Management Programming Manual

Common Definitions
X25AM Management Programming Manual—528037-001
5-9
Common Definitions for the X25AM Subsystem
ZCOM-VAL-SUMSTATE-DIAG
is a value of the field ZSTATE of the extensible structured tokens ZX25-MAP-
STATUS-LINE and ZX25-MAP-STATUS-SU. It indicates that an X25AM line or
subdevice is in the DIAGNOSING summary state. For more information, see the
STATUS command in Section 6, Commands and Responses.
ZCOM-VAL-SUMSTATE-STARTED
is a value of the field ZSTATE of the extensible structured tokens ZX25-MAP-
STATUS-LINE and ZX25-MAP-STATUS-SU. It indicates that an X25AM line or
subdevice is in the STARTED summary state. For more information, see the
STATUS command in Section 6, Commands and Responses.
ZCOM-VAL-SUMSTATE-STOPPED
is a value of the field ZSTATE of the extensible structured tokens ZX25-MAP-
STATUS-LINE and ZX25-MAP-STATUS-SU. It indicates that an X25AM line or
subdevice is in the STOPPED summary state. For more information, see the
STATUS command in Section 6, Commands and Responses.
Common Definitions for the X25AM
Subsystem
Definitions whose names begin with ZX25- are X25AM definitions.
Those X25AM definitions that appear in several commands or responses are
described in this section. Information about these definitions that is specific to
particular commands or responses is discussed in Section 6, Commands and
Responses.
This section also describes those X25AM definitions that are not described elsewhere
in the manual, such as the X25AM subsystem version number.
Definitions are listed in alphabetical order within each category.
Buffer Declarations
The X25AM subsystem provides the following buffer declarations for message buffers
that can be used with the SPI procedures. All applications should use one of these
declarations for a buffer of the recommended size.
ZX25-DDL-MSG-BUFFER
is a message buffer whose size is that recommended for command messages and
for responses in which each reply message contains a single response record.