X25AM Management Programming Manual

X25AM Management Programming Manual—528037-001
6-1
6 Commands and Responses
This section describes the syntax and semantics for all commands and responses in
the programmatic control-and-inquiry interface to the X25AM subsystem.
These commands allow an application to do the following:
•
Change the attributes of X25AM objects
•
Start and stop the operation of X25AM objects
•
Add subdevices to or remove subdevices from the X25AM subsystem
•
Control whether or not other applications can open a subdevice
•
Obtain attribute values
•
Obtain statistical and status information
•
Obtain information about the object names known to the X25AM subsystem
•
Trace the operation of X25AM lines
In this section, command numbers, object types, and all tokens and their values are
represented in DDL. For a quick explanation of DDL as it applies to SPI, refer to the
appendix "Summary of DDL for SPI" in the SPI Programming Manual.
This section contain these topics:
Table 6-1 lists all the commands that are available in the programmatic control-and-
inquiry interface to the X25AM subsystem and gives their symbolic names.
Topic Page
Commands by Object Type
6-3
Sensitive and Nonsensitive Commands 6-3
Command Descriptions 6-4
Examples of Commands and Responses 6-149
Table 6-1. Commands and Their Symbolic Names (page 1 of 2)
Command Symbolic Name of Command and Object
ABORT ZCOM-CMD-ABORT ZCOM-OBJ-LINE
ZCOM-OBJ-SU
ADD ZCOM-CMD-ADD ZCOM-OBJ-SU
ALLOWOPENS ZCOM-CMD-ALLOWOPENS ZCOM-OBJ-LINE
ZCOM-OBJ-SU
ALTER LINE
PROCESS
SUBDEVICE
ZCOM-CMD-ALTER ZCOM-OBJ-LINE
ZCOM-OBJ-PROCESS
ZCOM-OBJ-SU