X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual—528037-001
6-13
ADD Command
ZPROTO
specifies the protocol to be used by the subdevice. This field is required and
must be assigned one of the following values:
ZREC-SIZE
specifies the maximum length in bytes of records sent or received by the
subdevice. This field is required and must be assigned a value in the range 0
through 4095.
ZACCEPT-CHG
specifies whether or not an incoming call request asking that the recipient pay
the charge will be accepted. This field can be assigned the following values:
If no value is assigned to this field, charges will not be accepted.
ZBLOCK-PAD-CNT
specifies the number of parameter pairs that appear in the field ZBLOCK-PAD-
PARAMS. This field can be assigned a value in the range 0 through 63. If the
value is 0, it indicates that no block-mode PAD parameters are being explicitly
specified.
ZBLOCK-PAD-PARAMS
consists of from 0 through 63 pairs of integers that specify the block-mode
X.29 PAD parameters. The number of integer pairs in this field is given by the
value of the field ZBLOCK-PAD-CNT. PAD parameters are valid only if the
protocol is ITI.
ZCONV-PAD-CNT
specifies the number of parameter pairs that appear in the field ZCONV-PAD-
PARAMS. This field can be assigned a value in the range 0 through 63. If the
value is 0, it indicates that no conversational-mode PAD parameters are being
explicitly specified.
ZCONV-PAD-PARAMS
consists of from 0 through 63 pairs of integers that specify the conversational-
mode X.29 PAD parameters. The number of integer pairs in this field is given
ZX25-VAL-PROTO-ITI The Interactive Terminal Interface (ITI) protocol will
be used.
ZX25-VAL-PROTO-NAM The Network Access Method (NAM) protocol will
be used.
ZX25-VAL-PROTO-PTP The Process-to-Process (PTP) will be used.
ZSPI-VAL-TRUE Charges will be accepted.
ZSPI-VAL-FALSE Charges will not be accepted.