X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual—528037-001
6-16
ADD Command
Parity checking is disabled by default. If enabled, parity checking is performed
as specified by the value of the field ZPARITY. This field is valid only if the
protocol is ITI.
ZPORT
specifies the logical port number to be used by the subdevice. This field can be
assigned a value in the range 0 through 9999; the default value is 0.
ZPRI-CALL
specifies whether or not the capability of making priority calls is enabled. This
field applies only to DATAPAC. This field can be assigned the following values:
The capability of making priority calls is disabled by default. This field applies
only to the DATAPAC network.
ZPVC
specifies the channel number of the Permanent Virtual Circuit (PVC) that the
subdevice is bound with. This field can be assigned a value in the range 0
through 4095.
ZRMT-NET
specifies the addressing conventions to be used when building the called
address in a call-request packet. This field can be assigned the following
values:
ZSPI-VAL-TRUE The capability of making priority calls is enabled.
ZSPI-VAL-FALSE The capability of making priority calls is disabled.
ZX25-VAL-NETID-DATANET The addressing conventions for the DATANET
network are used.
ZX25-VAL-NETID-DATAPAC The addressing conventions for the DATAPAC
network are used.
ZX25-VAL-NETID-DATEXP The addressing conventions for the DATEX-P
network are used.
ZX25-VAL-NETID-DDXP The addressing conventions for the DDXP
(NTT) network are used.
ZX25-VAL-NETID-PSS The addressing conventions for the PSS
network are used.
ZX25-VAL-NETID-TELENET The addressing conventions for the TELENET
network are used.
ZX25-VAL-NETID-TRANSPAC The addressing conventions for the TRANSPAC
network are used.
ZX25-VAL-NETID-TYMNET The addressing conventions for the TYMNET
network are used.