X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual—528037-001
6-29
ALTER LINE Command
ZSRC-ADDR
specifies the X.25 network address for your system. This field is required and
must be assigned a string of from 1 through 15 decimal-digit characters. This
field has no corresponding SYSGEN modifier.
ZFILLER
acts as a filler and is not associated with any line attribute. This field has no
corresponding SYSGEN modifier.
ZBLOCK-PAD-CNT
specifies the number of parameter pairs that appear in the field ZBLOCK-PAD-
PARAMS. This field can be assigned a value in the range 0 through 63, or the
value -1. If the value is 0, it indicates that the block-mode PAD parameters are
not to be altered. The value -1 must be used to clear all explicitly specified
block-mode PAD parameters. This field has no corresponding SYSGEN
modifier.
ZBLOCK-PAD-PARAMS
consists of from 0 through 63 pairs of integers that specify the block-mode
X.29 PAD parameters. The number of integer pairs in this field is given by the
value of the field ZBLOCK-PAD-CNT. Specifying a PAD parameter overrides
the normal setting for that parameter for all frames. PAD parameters are valid
only if the subdevice protocol is ITI. This field has no corresponding SYSGEN
modifier.
ZCALLING-ADDR
specifies whether or not the X25AM subsystem sends the network address
given by the field ZSRC-ADDR as the calling address in outgoing call-request
packets. This field can be assigned the following values:
ZX25-VAL-NETID-X25SA The addressing conventions of the generic netid
X25SA are used. This value corresponds to the
SYSGEN modifier X25SA.
ZX25-VAL-NETID-X25UD The addressing conventions of the generic netid
X25UD are used. This value corresponds to the
SYSGEN modifier X25UD.
ZX25-VAL-NETID-X25XA The addressing conventions of the generic netid
X25XA are used. This value corresponds to the
SYSGEN modifier X25XA.