X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual—528037-001
6-45
ALTER SUBDEVICE Command
ZACCEPT-CHG
specifies whether or not an incoming call request asking that the recipient pay
the charge will be accepted. This field can be assigned the following values:
By default, charges will not be accepted.
ZBLOCK-PAD-CNT
specifies the number of parameter pairs that appear in the field ZBLOCK-PAD-
PARAMS. This field can be assigned a value in the range 0 through 63, or the
value -1. If the value is 0, it indicates that the block-mode PAD parameters are
not to be altered. The value -1 must be used to clear all explicitly specified
block-mode PAD parameters.
ZBLOCK-PAD-PARAMS consists of from 0 through 63 pairs of integers that
specify the block-mode X.29 PAD parameters. The number of integer pairs in
this field is given by the value of the field ZBLOCK-PAD-CNT. PAD parameters
are valid only if the protocol is ITI.
ZCONV-PAD-CNT
specifies the number of parameter pairs that appear in the field ZCONV-PAD-
PARAMS. This field can be assigned a value in the range 0 through 63, or the
value -1. If the value is 0, it indicates that the conversational-mode PAD
parameters are not to be altered. The value -1 must be used to clear all
explicitly specified conversational-mode PAD parameters.
ZCONV-PAD-PARAMS
consists of from 0 through 63 pairs of integers that specify the conversational-
mode X.29 PAD parameters. The number of integer pairs in this field is given
by the value of the field ZCONV-PAD-CNT. PAD parameters are valid only if
the protocol is ITI.
ZCUG
specifies the closed user group (CUG) identification that might be included as a
facility in call-request packets. This field can be assigned a value in the range 0
through 9999, or the value -1. The value -1 must be used to clear an explicitly
specified CUG identification. If there is no CUG identification for a subdevice,
the value of the CUG identification attribute of the associated line is sent in
call-request packets. The value depends on the value of CUGTYPE (see
ZCUG-TYPE on page 6-50).
ZDEST-ADDR
specifies the network address that the subdevice will use as the called address
in outgoing call-request packets. This field can be all blanks, in which case
ZSPI-VAL-TRUE Charges will be accepted.
ZSPI-VAL-FALSE Charges will not be accepted.