X25AM Management Programming Manual

Commands and Responses
X25AM Management Programming Manual—528037-001
6-48
ALTER SUBDEVICE Command
The capability of making priority calls is disabled by default. This field applies
only to the DATAPAC network.
ZPVC
specifies the channel number of the Permanent Virtual Circuit (PVC) that the
subdevice is bound with. This field can be assigned a value in the range 0
through 4095, or the value -1. The value -1 must be used to clear an explicitly
specified PVC. The value must be within the line PVCRANGE.
ZRMT-NET
specifies the addressing conventions to be used when building the called
address in a call-request packet. This field can be assigned the following
values:
By default, the addressing conventions are specified by the network-
identification attribute of the line associated with the subdevice.
ZX25-VAL-NETID-DATANET The addressing conventions for the DATANET
network are used.
ZX25-VAL-NETID-DATAPAC The addressing conventions for the DATAPAC
network are used.
ZX25-VAL-NETID-DATEXP The addressing conventions for the DATEX-P
network are used.
ZX25-VAL-NETID-DDXP The addressing conventions for the DDXP
(NTT) network are used.
ZX25-VAL-NETID-PSS The addressing conventions for the PSS
network are used.
ZX25-VAL-NETID-TELENET The addressing conventions for the TELENET
network are used.
ZX25-VAL-NETID-TRANSPAC The addressing conventions for the TRANSPAC
network are used.
ZX25-VAL-NETID-TYMNET The addressing conventions for the TYMNET
network are used.
ZX25-VAL-NETID-X25 The addressing conventions of the generic netid
X25 are used.
ZX25-VAL-NETID-X25NP The addressing conventions of the generic netid
X25NP are used.
ZX25-VAL-NETID-X25SA The addressing conventions of the generic netid
X25SA are used.
ZX25-VAL-NETID-X25UD The addressing conventions of the generic netid
X25UD are used.
ZX25-VAL-NETID-X25XA The addressing conventions of the generic netid
X25XA are used.