X25AM Programming Manual

X3PAD Interface
X25AM Programming Manual—527201-001
4-17
SET Command
ERROR: I CANNOT OPEN file.
If file does not exist, a message is written to the OUT file. X3PAD resumes
executing terminal commands.
ERROR: THERE IS NO CALL IN PROGRESS.
A call must be in progress as a result of the CALL command for the SEND
command to execute. If a call is not in progress, a message is written to the OUT
file.
SET Command
The SET command sets operational parameters for X3PAD.
Table 4-16 shows each parameter (param) and the parameter values (param-value)
associated with each parameter. A description of each parameter value follows the
table.
SET param param-value
Table 4-16. X3PAD SET Description
param param-value
ADDRESS address
BREAK break action |
NONE
break action is [ DISCARD ]
[ ESCAPE ]
[ INTERRUPT ]
[ SEND ]
CHARKILL character
CRDELAY integer | NONE
DISCARD ON | OFF
ECHO ON | OFF
EDITING ON | OFF
ESCAPE character | NONE
LFDELAY integer | 0
LFINSERT data stream |
NONE
data stream is [ ECHO ]
[ SEND ]
[ RECEIVE ]