X25AM Programming Manual

X3PAD Interface
X25AM Programming Manual—527201-001
4-22
SHOW Command
ERROR: SPEED CANNOT BE SET.
SHOW Command
The SHOW command displays the current value of X3PAD operational
parameters.
param
specifies the parameter to be displayed. The display is written to the OUT file. If
param is omitted, the values of all operational parameters are displayed with one
value per line.
Parameter values for param are described in Table 4-16 on page 4-17.
STATUS Command
The STATUS command displays the status of the current call.
Table 4-17summarizes potential STATUS error messages.
THERE IS NO CALL IN PROGRESS. clear-indication
If no call is in progress, the clear-indication of the most recent call is written to the
OUT file.
CALL IN PROGRESS. call-status
If a call is in progress, its status is written to the OUT file.
The example of call-status is:
ADDRESS address
integer PACKETS SENT.
integer PACKETS RECEIVED.
integer:integer:integer ELAPSED TIME.
SHOW [ param ]
STATUS
Table 4-17. STATUS Command Messages Issued by X3PAD
THERE IS NO CALL IN PROGRESS.
clear-indication
CALL IN PROGRESS.
call-status