X25AM Programming Manual

ITI Applications
X25AM Programming Manual—527201-001
2-11
PAD Parameters
controls the echo of input data at the terminal, results in a SET PAD PARAMETER
command with the appropriate value of 0,1 for parameter 2.
PAD Parameters Used by ITI
ITI does not set all PAD parameters. Table 2-4 summarizes the X.3 PAD parameters
(with default values) normally set by ITI.
Table 2-4. PAD Parameters Set by ITI (page 1 of 2)
Number Parameter
Parameter Value
Conversation Mode (6510
Page Mode)
Page Mode for 6520 and
6530
1 PAD Command
mode by escaping
from data transfer
mode
1 = DLE 0 = No PAD command
mode
2 Character echo 0 = No echo
1 = Echo
Requires SETMODE 20 = 1
Conversation mode only.
Not for page mode.
0 = No echo
3 Selection of PAD
data forwarding
characters
2,126
Determined by SETMODE 9
Not for page mode.
0 = No data forwarding
character
4 Idle Timer Delay 0 = 0 ms 2 = 500 ms
5 Ancillary device
control
Not set 0 = No XON/XOFF
6 Suppression of
network messages
Not set 0 = No messages
7 Break handling 21 = Send Interrupt packet
Use Indication Of Break
message
Discard buffer content
21 = Same
8 Discard output 0 = Restore normal data
delivery to terminal
0 = Same
9 Padding after
receipt of CR from
terminal
Not set 0 = No padding
10 Line folding 0 = None 0 = None