XYGATE Access Control Reference Manual

XYGATE
®
Access Control Reference Manual
Chapter 7. XAC Auditing and Audit Reports
XYPRO Technology Corporation 76 Proprietary and Confidential
7.6 Interactive XAC_REPORTs
Ad-hoc reports can be obtained from the audit files by using the XAC-supplied report
macro. The report macro is named based on the name selected for invoking
XYGATEAC ACACL Command Entries. For example, if XAC was selected as the
TACL Macro to invoke XYGATEAC commands, the invocation for the ad-hoc report
macro would be XAC_REPORT. The report macro will allow you to select an audit trail
to report from, the date range, the user, and the ACACL Command Entry.
Syntax:
XAC_REPORT [-D]
The optional –D switch causes the entire ENFORM run to be displayed. Without the
switch, only the final summary lines are displayed.
Note: Without the -D option, only the summary of the ENFORM report will be shown
unless errors occur in the ENFORM run. If an error occurs, the entire ENFORM
run will be displayed. If -D is specified, the entire ENFORM run will be displayed
even if there are no errors.
Example:
$SYSTEM.SECURITY 2> XAC_REPORT
Choose an option:
A: Audit file :$SYSTEM.XYGATEAC.AUDIT
B: Report date range :2011-02-17 00:00 to 2011-02-17 23:59
C: Subject Userid :*.*
D: Subject Login name :*
E: Subject Terminal :*
F: Command :*
G: Display Output :No
H: Violations only :No
I: Output file :$S.#XYGATE.ACCESS
J: Sort order :USER
K: User specified title :*
L: User Input :*
M: IP Address :*
X: Exit the report macro
Z: Run the audit report
ZP: Run the audit report and go into PERUSE and return here
Hit Break or Control-Y to terminate
Selection?
Once the Report Selection screen is displayed, enter the letters, one at a time, for the
items you wish to change. After each entry, the Report Selection screen will be
displayed again, showing the selections you have made so far.
When you are satisfied with all your selection criteria, press Z to create the report and
exit from the XAC_REPORT macro.