XYGATE Access Control Reference Manual

XYGATE
®
Access Control Reference Manual
Appendix C: The ACACL File
XYPRO Technology Corporation 226 Proprietary and Confidential
In order to use the SAFEGUARD_PRIVLOGON option, create a Safeguard DISKFILE
Protection Record for the XYGATEAC object file and set attribute PRIV-LOGON to ON
as shown below.
Example 5: The DISKFILE Protection Record for the XAC Object File
LAST-MODIFIED OWNER STATUS WARNING-MODE
$SYSTEM.XYGATEAC
XYGATEAC 10AUG08, 1:01 \*.253,1 THAWED OFF
\*.253,1 R,W,E,P,C,O
\*.*,* R,E
AUDIT-ACCESS-PASS = NONE AUDIT-MANAGE-PASS = ALL
AUDIT-ACCESS-FAIL = ALL AUDIT-MANAGE-FAIL = ALL
AUDIT-PRIV-LOGON = ON
LICENSE = ON PROGID = ON CLEARONPURGE = OFF PERSISTENT = ON
TRUST = OFF PRIV-LOGON = ON
The XYGATEAC object file must be PROGID’d and LICENSED. Setting PERSISTENT
to ON will preserve the Protection Record when an XAC software upgrade is
performed. Security best practice requires that AUDIT-PRIV-LOGON be set to ON.
Note: The Safeguard PRIV-LOGON feature allows a program to set a special flag
when calling USER_AUTHENTICATE_, and if the program also has a
Safeguard diskfile ACL that has the Safeguard PRIV-LOGON attribute set (valid
values are ON and OFF), logons are then allowed without specifying a
password regardless of the Safeguard PASSWORD-REQUIRED setting. Also,
successive logon authentication failures will not be subjected to timeouts.
When an XAC command is configured with:
USER_SWITCH SAFEGUARD_PRIVLOGON
and XYGATEUA is in use, then the XUA UAGROUP used to authorize the logon
operation must have a setting of SAFEGUARD_PRIVLOGON ON. If this setting
is not present, then XAC’s attempt to switch users will fail, and the XAC
command will not run. Refer to the XYGATE User Authentication (XUA)
Reference Manual for the SAFEGUARD_PRIVLOGON keyword which is
described in “The UAACL File” appendix (refer to “Additional XYPRO Reference
Manuals” in the “Introduction” for the instructions on how to get this and other
XYPRO manuals).
XYGATEUA will only respect the Safeguard PRIV-LOGON flag set to ON if
SAFEGUARD_PRIVLOGON keyword is set to ON for a UAGROUP in the
UAACL file. The default value is OFF.