XYGATE Access Control Reference Manual

XYGATE

Access Control Reference Manual

Chapter 1. Installing XAC

XYPRO Technology Corporation 12 Proprietary and Confidential

If you know the location of the initial installation staging subvolume, overwrite that

using the PURGE option of FUP. This will ensure that the installed environments

are correctly upgraded to the most current product.

Syntax:

$MYVOL IXYPROAC 3> FUP DUP <$VOL>.ZXYPROAC.* EXCLUDE Z*,<$VOL>.<NEWSVOL>.*,PURGE,SAVEALL

Example:

$MYVOL IXYPROAC 3> FUP DUP $DSCSCM.ZXYPROAC.* EXCLUDE Z*,$MYVOL.IXYPROAC.*,PURGE,SAVEALL

Note: If you know that the initial installation staging subvolume is already deleted

or purged, leave out the PURGE option of FUP.

4. You can now run the AutoInstall script described in the next section. You may want

to review that script with your system manager before you begin.

5. Obey the file IXYBIN to unpack executable files and prepare the files for the

automated install script.

Syntax:

$MYVOL ZXYPROAC 4> OBEY IXYBIN

Example:

$MYVOL ZXYPROAC 4> OBEY IXYBIN

#FRAME

#PUSH #INFORMAT

#SET #INFORMAT TACL

UNPAK'ing SELF EXTRACTING OBEY FILE ...

1.3.2 Running AutoInstall to Upgrade XTR Only

Access to SUPER.SUPER (or an alias to SUPER.SUPER) will be required during the

upgrade to perform necessary licensing tasks in a separate TACL session. This

requirement will be indicated by the AutoInstall script and is also documented in this

procedure.

Note: The AutoInstall script waits on a prompt while the user starts a separate TACL

session when requested to perform specific actions. The user continues the

script after the action by responding to this prompt. However, if the user stops

the AutoInstall script for any reason, it must be restarted with the RUN

command as shown below. This will continue the upgrade from the point of exit.

Start the IWIZARD script.

Example:

TACL> RUN IWIZARD