XYGATE Access Control Reference Manual

XYGATE
®
Access Control Reference Manual
Chapter 1. Installing XAC
XYPRO Technology Corporation 14 Proprietary and Confidential
The AutoInstall script will attempt to locate any already installed XAC environments
and display these located environments as shown below.
Discovering XAC ($*.*) ...
Discovery complete.
SEL LOCATION VERSION OWNER AVAILABILITY
--- ----------------- ------- ----------------- ------------
1) $VOL.JIM XYPRO.JAMES Available
2) $VOL.XYGATEAC 5.65 XYPRO.JAMES Available
P) Prompt for new location Available
Press BREAK or <CONTROL>-Y to exit.
Enter available selection:
Choose the number (under the SEL heading) of an existing environment. Only
environments that are owned by your userid are available for selection. Other
environments are shown for information only.
Enter available selection: 2
Updating config ...
Config updated.
Product locations established.
Available version of XAC is not higher than the
installed version. XAC installation skipped.
Performing verifications ...
If the installed XAC software product version is the same or newer than the version
being installed by the script, the upgrade will be skipped as shown above.
The AutoInstall script now checks the installed XTR version number against the
available version as shown below.
Verifying the system catalog can be written to ...
Verified the system catalog can be written to.
Verifications complete.
Unpaking products:
Unpaking XTRBIN ...
Unpak of XTRBIN complete.
Unpaking products complete.
Installing products:
If the installed software is older than the current version, the script will notify you and
perform the upgrade. Upgrading the XTR software requires licensing of one of the
installation programs to perform this function.
Comparing installed version of XTR to available version ...
A higher version of XTR was found.
XTR will be upgraded.
$VOL.P46DSDST.IADOPTN4 is not licensed.
Cannot continue until these files are licensed by SUPER.SUPER. Please