XYGATE Access Control Reference Manual

XYGATE
®
Access Control Reference Manual
Chapter 1. Installing XAC
XYPRO Technology Corporation 15 Proprietary and Confidential
go to another TACL session, logon as SUPER.SUPER or an alias of SUPER.SUPER,
and license these files. You may continue when this has been done.
If you decide not to continue, the next time the wizard is run, the wizard
will continue where you last stopped.
To license these files, enter the following commands:
FUP LICENSE $VOL.P46DSDST.IADOPTN4
Are you ready to continue <Y/N>?
Do not answer the above prompt yet.
Start a separate TACL session using a SUPER.SUPER logon, and perform the
necessary licensing tasks as shown in the Example below.
Example:
TACL> FUP LICENSE $VOL.P46DSDST.IADOPTN4
TACL> Logoff as the SUPER.SUPER or SUPER alias
When you complete the licensing tasks, answer Y to the prompt below to continue.
Are you ready to continue <Y/N>? Y
Establishing product locations ...
Product locations established.
Performing verifications ...
Verifications complete.
Installing products:
If the installed software is older than the current version, the script will notify you and
perform the upgrade. Upgrading the XTR software requires licensing of one of the
installation programs to perform this function.
Comparing installed version of XTR to available version ...
A higher version of XTR was found.
XTR will be upgraded.
Installing XTR from \N1.$VOL.P46DSDST ...
Install of XTR complete.
Install of products complete.
XTR has not been finished via SUPER.SUPER.
Please go to another TACL session, logon as SUPER.SUPER or an alias of
SUPER.SUPER, and
RUN $VOL.XYGATETR.XTR INSTALL
XTR_FINISH_INSTALL
You may continue when this has been done.
If you decide not to continue, the next time the wizard is run, it will
start here, where you last stopped.
Are you ready to continue <Y/N>?
Do not answer the above prompt yet.