XYGATE Access Control Reference Manual

XYGATE
®
Access Control Reference Manual
Chapter 1. Installing XAC
XYPRO Technology Corporation 19 Proprietary and Confidential
Verifications complete.
Installing products:
If the installed software is older than the current version, the script will notify you and
perform the upgrade. Upgrading the XAC software requires licensing of one of the
installation programs to perform this function.
Comparing installed version of XAC to available version ...
A higher version of XAC was found.
XAC will be upgraded.
Installing XAC from \N1.$VOL.ZXYPROAC ...
Install of XAC complete.
Install of products complete.
XAC has not been finished via SUPER.SUPER.
Please go to another TACL session, logon as SUPER.SUPER or an alias of
SUPER.SUPER, and
RUN $VOL.XYGATEAC.XAC INSTALL
XAC_FINISH_INSTALL
You may continue when this has been done.
If you decide not to continue, the next time the wizard is run, it will
continue here, where you last stopped.
Are you ready to continue <Y/N>?
Do not answer the above prompt yet.
Start another TACL session using a SUPER.SUPER logon, and perform the licensing
tasks as directed by the script. The specific licensing instructions vary depending on
which products were installed or upgraded.
Licensing requirements are to be performed by a SUPER.SUPER logon for XAC only:
Example:
TACL> RUN $VOL.XYGATEAC.XAC INSTALL
TACL> XAC_FINISH_INSTALL
Licensing $VOL.XYGATEAC.XYGATEAC
Licensing $VOL.XYGATEAC.XYGATEAD
Licensing $VOL.XYGATEAC.VULIB
Licensing $VOL.XYGATEAC.XOADLL
Licensing $VOL.XYGATEAC.USERINFO
TACL> Logoff as the SUPER.SUPER or SUPER alias
When you complete the licensing tasks, answer Y to the prompt below to continue.
Are you ready to continue <Y/N>? Y
Establishing product locations ...
Product locations established.
Performing verifications ...
Verifications complete.