XYGATE Access Control Reference Manual

XYGATE
®
Access Control Reference Manual
Chapter 1. Installing XAC
XYPRO Technology Corporation 22 Proprietary and Confidential
Press BREAK or <CONTROL>-Y to exit.
Enter available selection:
Choose the number (under the SEL heading) of an existing environment. Only
environments that are owned by your userid are available for selection. Other
environments are shown for information only.
Enter available selection: 2
Updating config ...
Config updated.
Product locations established.
Performing verifications ...
If the installed XAC software product version is the same or newer than the version
being installed by the script, the upgrade will be skipped as shown above.
Verifying the system catalog can be written to ...
Verified the system catalog can be written to.
Verifications complete.
Unpaking products:
Unpaking XTRBIN ...
Unpak of XTRBIN complete.
Unpaking products complete.
Installing products:
If the installed software is older than the current version, the script will notify you and
perform the upgrade. Upgrading the XAC software requires licensing of one of the
installation programs to perform this function.
Comparing installed version of XAC to available version ...
A higher version of XAC was found.
XAC will be upgraded.
Installing XAC from \N1.$VOL.ZXYPROAC ...
Install of XAC complete.
If the installed software is older than the current version, the script will notify you and
perform the upgrade. Upgrading the XTR software requires licensing of one of the
installation programs to perform this function.
Comparing installed version of XTR to available version ...
A higher version of XTR was found.
XTR will be upgraded.
$VOL.P46DSDST.IADOPTN4 is not licensed.
Cannot continue until these files are licensed by SUPER.SUPER. Please go to
another TACL session, logon as SUPER.SUPER or an alias of SUPER.SUPER, and
license these files. You may continue when this has been done.
If you decide not to continue, the next time the wizard is run, the wizard
will continue where you last stopped.
To license these files, enter the following commands: