XYGATE Access Control Reference Manual

XYGATE
®
Access Control Reference Manual
Chapter 1. Installing XAC
XYPRO Technology Corporation 23 Proprietary and Confidential
FUP LICENSE $VOL.P46DSDST.IADOPTN4
Are you ready to continue <Y/N>?
Do not answer the above prompt yet.
Start a separate TACL session using a SUPER.SUPER logon, and perform the
necessary licensing tasks as shown in the Example below.
Example:
TACL> FUP LICENSE $VOL.P46DSDST.IADOPTN4
TACL> Logoff as the SUPER.SUPER or SUPER alias
When you complete the licensing tasks, answer Y to the prompt below to continue.
Are you ready to continue <Y/N>? Y
Establishing product locations ...
Product locations established.
Performing verifications ...
Verifications complete.
Installing products:
Comparing installed version of XTR to available version ...
A higher version of XTR was found.
XTR will be upgraded.
Installing XTR from $VOL.P46DSDST ...
Install of XTR complete.
Install of products complete.
Newly installed XYGATE products have not been licensed via SUPER.SUPER.
Please go to another TACL session, logon as SUPER.SUPER or an alias of
SUPER.SUPER, and
RUN \N1.$VOL.ZXYPROAC.LICENSE
You may continue when this has been done.
If you decide not to continue, the next time the wizard is run, it will
continue here, where you last stopped.
Are you ready to continue <Y/N>?
Do not answer the above prompt yet.
Start another TACL session using a SUPER.SUPER logon, and perform the licensing
for both
XAC and XTR as directed by the script.
Example:
TACL> RUN \N1.$VOL.ZXYPROAC.LICENSE
Licensing $VOL.XYGATEAC.XYGATEAC
Licensing $VOL.XYGATEAC.VULIB
Licensing $VOL.XYGATEAC.XOADLL
Licensing $VOL.XYGATEAC.USERINFO
Licensing $VOL.XYGATETR.ADOPT
Licensing $VOL.XYGATETR.USERINFO
TACL> Logoff as the SUPER.SUPER or SUPER alias