XYGATE Access Control Reference Manual

XYGATE
®
Access Control Reference Manual
Chapter 1. Installing XAC
XYPRO Technology Corporation 25 Proprietary and Confidential
1.4.1 Preparing for the Auto Uninstall Script
The Auto Uninstall script will attempt to uninstall all modules that are running on the
server as follows:
• Uninstall the XYGATEAC installed product software.
• Uninstall the XYGATETR installed product software.
• Stop the LISTNER process for the connection of GUI products to XYGATETR.
1. Locate the installation subvolume where the XAC product AutoInstall script was
executed.
Syntax:
TACL> VOLUME <$NEWVOL>.ZXYPROAC
Example:
TACL> VOLUME $MYVOL.ZXYPROAC
2.
If the UNIWIZ script does not exist, use the following command to unpack the
software and make the script accessible:
TACL> OBEY IXYBIN
3.
Start the UNIWIZ script with the parameter Y.
Example:
TACL> RUN UNIWIZ Y
The UNIWIZ script requires the parameter Y to perform the uninstall. This
parameter is designed to stop inadvertent use of this tool. The script will display the
locations specified for XTR and XAC installations from the last time the IWIZARD
auto-install tool was run; otherwise, it will prompt for the installation locations to be
uninstalled.
Important! All files in the displayed locations will be purged. You will be prompted
to verify that this is correct and are therefore responsible to verify that this is
accurate before continuing. Failure to do so could inadvertently purge files possibly
belonging to a different product installation for which removal was not intended.
Examining environment ...
Done examining environment.
XYGATE XTR and XAC Products Uninstall
WARNING:
This will remove ALL files from the following locations, even if the
product was not recently installed or upgraded:
XTR Installed files on \N1.$VOL.XYGATETR
XAC Installed files on \N1.$VOL.XYGATEAC
Are you ready to continue <Y/N>?