XYGATE Compliance PRO (XSW) Reference Manual

XYGATE

Compliance PRO

™

Reference Manual

Chapter 1. Installing Compliance PRO (XSW)

XYPRO Technology Corporation 6 Proprietary and Confidential

Example:

Enter XTR volume <$DAT90>? 

In the above example, $DAT90 is accepted as the default XTR volume.

Script prompts will return an error to the screen if the entered value is not valid. You

can then change your response to a valid entry.

Example:

Enter XTR volume <$DAT90>? Zmywrk

Invalid volume entry, try again

Invalid response

You can end the script by pressing Ctrl+Y at any prompt. Stopping the script will end

the install or upgrade prematurely. You can restart the script by re-running the

IWIZARD program. It will attempt to restart at the point you ended.

Example:

Enter XSW volume <$VTOI>?EOF!

$VTOI ZIMYXSW 6>

1.3.3 Before You Begin Running the AutoInstall Script

Before you attempt to run this AutoInstall script, be sure you have reviewed the

preparations and the configuration values listed in the Tables at the beginning of this

section, and have read the subsection “Using the AutoInstall Script Tool.”

1. Locate the distributed subvol (DSV) ZXYPROSW. The DVD setup program

defaults to placing the software on the host in $SYSTEM.ZXYPROSW.

You should not run the AutoInstall script from the DSV location because values in

files get changed during the installation process, and the starting values might be

needed to restore the installation software to its original state. Decide on a location

to be used as a staging location and set the current volume to that location.

Syntax:

TACL> VOLUME [$NEWVOL].ZXYPROSW

Example:

TACL> VOLUME $MYVOL.ZXYPROSW

Duplicate the DSV to the new installation staging location.

Syntax:

$MYVOL ZXYPROSW 3> FUP DUP [$VOL].ZXYPROSW.* EXCLUDE Z*,[$VOL].[NEWSVOL].*,PURGE,SAVEALL

Example:

$MYVOL ZXYPROSW 3> FUP DUP $DSCSCM.ZXYPROSW.* EXCLUDE Z*,$MYVOL.ZXYPROSW.*,PURGE,SAVEALL

3. Ensure that an IP44F001 license file is in the $VOL.ZXYPROSW subvolume.