Manualshelf

XYGATE Compliance PRO (XSW) Reference Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series
21222324252627282930
XYGATE
®
Compliance PRO
™
Reference Manual
Chapter 1. Installing Compliance PRO (XSW)
XYPRO Technology Corporation 8 Proprietary and Confidential
SUPER.SUPER) at the time of the initial installation, the user has
the option to stop the installation. The next time the user runs the
IWIZARD, the installation process will continue from the point where
it was stopped.
Are you ready to continue <Y/N>? Y
The AutoInstall script will attempt to locate any installed XTR environments and will
display these located environments as shown below. If you are running this script to
upgrade one of these environments, refer to section 1.4, “Upgrading XSW Using the
AutoInstall Script” starting on page 12.
Establishing product locations ...
-------------------------------------------------------------------------------
The XYGATE Transaction Router (XTR) is used to provide communication between
XYGATE GUI products and their HP NonStop server counterparts. The transaction
router provides the connection between the PC and the NonStop host via a
LISTNER.
One installation of XTR can be utilized by all the XYGATE GUI products, so you
only need to configure one port on each host even if you are using more than
one XYGATE GUI product.
Discovering XTR ($*.*) ...
Discovery complete.
SEL LOCATION VERSION OWNER AVAILABILITY
--- ----------------- ------- ----------------- ------------
1) $VOL.XTR160 1.60 XYPRO.JAMES Available
2) $VOL.XTRTEMP 1.54 XYPRO.JAMES Available
P) Prompt for new location Available
Press BREAK or <CONTROL>-Y to exit.
Enter available selection:
If this is a new install, one of the following will be true:
no environments will be located or
no available environments will be located or
a new environment needs to be installed.
If existing environments are located, select the P option to install a new environment.
Enter available selection: P
Referring to Table 1 values, enter a Volume name or accept the default volume
displayed by the prompt.
Enter XTR volume <$VOL>?
Then enter the XTR subvolume name at the prompt. It would be helpful to identify this
subvolume as the XTR subvolume, using a name such as XYGATETR, or XTRPROD.
Enter XTR subvol <XTR156>?