XYGATE Compliance PRO (XSW) Reference Manual

XYGATE
®
Compliance PRO
™
Reference Manual
Chapter 1. Installing Compliance PRO (XSW)
XYPRO Technology Corporation 10 Proprietary and Confidential
Only <your userid> and SUPER.SUPER will be authorized to use
XYGATE GUI programs. You can optionally authorize additional
users and aliases by entering them at the next two prompts.
Pressing <ENTER> without providing additional users or
aliases means no additional users or alias will be authorized.
If this is a new install, you will be asked for any additional users/aliases (90-characters
max.) that you may want to have access to this environment. The AutoInstall script will
add any additional users to the access list for this environment.
Enter user id's, separated by spaces <>?
Enter aliases, separated by spaces <>?
If this is a new install, you will be asked for a port number. A port number will provide
the ability to set up the TCP/IP communication program to allow access from the
PC/GUI products. The port number must be between 1025 and 32000. If you specify a
port, be sure to make a note of it because you will need this number later when making
your connection from the GUI products.
Please select a port number in the recommended range 1025 - 32000.
What port do you want to use to communicate with GUI products <1120>? 1121
If you specify a port number already in use, the AutoInstall script will inform you that
the number is invalid, and then prompt you again.
When you specify a valid port number, the AutoInstall script will complete the
installation of the XYGATE products.
Customization of XTR complete.
Install of XTR complete.
Install of products complete.
Newly installed XYGATE products have not been licensed via SUPER.SUPER.
Please go to another TACL session, logon as SUPER.SUPER or an alias of
SUPER.SUPER, and
RUN \X.$VOL.ZXYPROSW.LICENSES
You may continue when this has been done.
If you decide not to continue, the next time the wizard is run, it will
continue here, where you last stopped.
Are you ready to continue <Y/N>?
Do not answer the prompt yet.
Start a separate TACL session using a SUPER logon, and perform the necessary
licensing tasks as shown in the Example below.