XYGATE Compliance PRO (XSW) Reference Manual

XYGATE
®
Compliance PRO
™
Reference Manual
Chapter 1. Installing Compliance PRO (XSW)
XYPRO Technology Corporation 14 Proprietary and Confidential
Example:
TACL> RUN IWIZARD
Initializing config file ...
Done initializing config file.
Warning: Access to SUPER.SUPER (or an alias to SUPER.SUPER) may be required to
complete the installation of each XYGATE product.
During the installation, if the need for SUPER.SUPER arises, the
installation will be paused and the user will be asked to issue
specific commands from another TACL prompt while logged on as
SUPER.SUPER (or an alias to SUPER.SUPER), after which the
installation can continue.
If these commands cannot be issued by SUPER.SUPER (or an alias to
SUPER.SUPER) at the time of the initial installation, the user has
the option to stop the installation. The next time the user runs the
IWIZARD, the installation process will continue from the point where
it was stopped.
Are you ready to continue <Y/N>? Y
The AutoInstall script will attempt to locate any already installed XTR environments
and display these located environments as shown below.
Establishing product locations ...
-------------------------------------------------------------------------------
The XYGATE Transaction Router (XTR) is used to provide communication between
XYGATE GUI products and their HP NonStop server counterparts. The transaction
router provides the connection between the PC and the NonStop host via a
LISTNER.
One installation of XTR can be utilized by all the XYGATE GUI products, so you
only need to configure one port on each host even if you are using more than
one XYGATE GUI product.
Discovering XTR ($*.*) ...
Discovery complete.
SEL LOCATION VERSION OWNER AVAILABILITY
--- ----------------- ------- ----------------- ------------
1) $VOL.XTR156 1.55 XYPRO.JAMES Available
2) $VOL.XTR160 1.59 XYPRO.JAMES Available
P) Prompt for new location Available
Press BREAK or <CONTROL>-Y to exit.
Enter available selection:
To run an upgrade, choose the number (under the SEL heading) of the existing
environment to be upgraded. Only environments that are owned by your userid are
available to be upgraded. Other environments are shown for information only.
Enter available selection: 1
Updating config ...
Config updated.