XYGATE Compliance PRO (XSW) Reference Manual

XYGATE
®
Compliance PRO
™
Reference Manual
Chapter 1. Installing Compliance PRO (XSW)
XYPRO Technology Corporation 21 Proprietary and Confidential
Taking inventory complete.
Validating the installation ...
A final status screen will display the current XSW environment.
Product Distribution Version Installed Version
-------- -------------------- -----------------
XSW 2.60 2.60
XTR 1.56 1.56
Listner is running and listening on port 1121.
-----------------------------------------------------------------
Validation finished. If no errors were reported, and the
information shown was as expected, the installation was
validated.
-----------------------------------------------------------------
1.4.3 Running the XTR and XSW AutoInstall Upgrade
Access to SUPER.SUPER (or an alias to SUPER.SUPER) will be required during the
upgrade to perform necessary licensing tasks in a separate TACL session. This
requirement will be indicated by the AutoInstall script and is also documented in this
procedure.
Note: The AutoInstall script waits on a prompt while the user starts a separate TACL
session when requested to perform specific actions. The user continues the
script after the action by responding to this prompt. However, if the user stops
the AutoInstall script for any reason, it must be restarted with the Run command
as shown below. This will continue the upgrade from the point of exit.
Start the IWIZARD script.
Example:
TACL> RUN IWIZARD
Initializing config file ...
Done initializing config file.
Warning: Access to SUPER.SUPER (or an alias to SUPER.SUPER) may be required to
complete the installation of each XYGATE product.
During the installation, if the need for SUPER.SUPER arises, the
installation will be paused and the user will be asked to issue
specific commands from another TACL prompt while logged on as
SUPER.SUPER (or an alias to SUPER.SUPER), after which the
installation can continue.
If these commands cannot be issued by SUPER.SUPER (or an alias to
SUPER.SUPER) at the time of the initial installation, the user has
the option to stop the installation. The next time the user runs the
IWIZARD, the installation process will continue from the point where
it was stopped.
Are you ready to continue <Y/N>? Y