XYGATE Compliance PRO (XSW) Reference Manual

XYGATE

Compliance PRO

™

Reference Manual

Chapter 1. Installing Compliance PRO (XSW)

XYPRO Technology Corporation 26 Proprietary and Confidential

1.5 Uninstalling XTR and XSW Using the Auto Uninstall Script

The Auto Uninstall script is designed for an easy removal of the XSW and XTR server

programs, and files. It should only be run if the IWIZARD was run to install or upgrade

the XSW and/or XTR environments and you want to completely remove the XSW and

XTR environments.

1.5.1 Preparing for the Auto Uninstall Script

The Auto Uninstall script will attempt to uninstall all modules that are running on the

server as follows:

• Uninstall the XYGATESW installed product software.

• Uninstall the XYGATETR installed product software.

• Stop the LISTNER process for the connection of GUI products to XYGATETR.

1. Locate the installation subvolume where the XSW product AutoInstall script was

executed.

Syntax:

TACL> VOLUME [$NEWVOL].ZXYPROSW

Example:

TACL> VOLUME $MYVOL.ZXYPROSW

If the UNIWIZ script does not exist, use the following command to unpack the

software and make the script accessible:

TACL> OBEY IXYBIN

Start the UNIWIZ script with the parameter Y.

Example:

TACL> RUN UNIWIZ Y

The UNIWIZ script requires the parameter Y to perform the uninstall. This

parameter is designed to stop inadvertent use of this tool. The script will display the

locations specified for XTR and XSW installations from the last time the IWIZARD

auto-install tool was run; otherwise, it will prompt for the installation locations to be

uninstalled.

Important! All files in the displayed locations will be purged. The user will be

prompted to verify that this is correct and is responsible for verifying that this is

accurate before continuing. Failure to do so could result in the inadvertent purging

of files possibly belonging to a different product installation for which removal was

not intended.