XYGATE Merged Audit Reference Manual

XYGATE Merged Audit
®
Reference Manual
Chapter 1. Installing XMA
XYPRO Technology Corporation 6 Proprietary and Confidential
You can end the script by pressing Ctrl+Y at any prompt. Stopping the script will end
the install or upgrade prematurely. You can restart the script by re-running the
IWIZARD program. It will attempt to restart at the point you ended.
Example:
Enter XMA volume <$VTOI>?EOF!
$VTOI ZIMYXMA 6>
1.2.3 Before You Begin Running the AutoInstall Script
Before you attempt to run this AutoInstall script, be sure you have reviewed the
preparations and the configuration values listed in the Tables at the beginning of this
section, and have read the subsection that describes Using the AutoInstall Script Tool.
1. Locate the distributed subvolume (DSV). The default name of this subvolume is
ZXYPROMA and will be located on the disc where the SUT copied “Z” type files to
the server.
You should not run the AutoInstall script from the DSV because it will get replaced
upon each SUT operating system installation. Decide on a subvolume name for a
new install location, and set the current volume to that location.
Syntax:
TACL> VOLUME <$NEWVOL>.IXYPROMA
Example:
TACL> VOLUME $MYVOL.IXYPROMA
1.
Duplicate the DSV to the new installation staging location.
Syntax:
$MYVOL IXYPROMA 3> FUP DUP <$VOL>.ZXYPROMA.* EXCLUDE Z*,<$VOL>.<NEWSVOL>.*,PURGE,SAVEALL
Example:
$MYVOL IXYPROMA 3> FUP DUP $DSCSCM.ZXYPROMA.* EXCLUDE Z*,$MYVOL.IXYPROMA.*,PURGE,SAVEALL
2. Ensure that a valid IP28F001 license file is on the <$VOL>.<NEWSVOL>
subvolume.
3. You are now ready to start the AutoInstall script. Review the questions you will be
asked during this script and obtain any answers from your system manager.
4. Obey the file IXYBIN to unpack executable files and prepare them for the
automated install script.
Syntax:
$MYVOL IXYPROMA 4> OBEY IXYBIN
Example:
$MYVOL IXYPROMA 4> OBEY IXYBIN