XYGATE User Authentication Reference Manual

XYGATE
®
User Authentication
™
(XUA) 1.85 Reference Manual
Chapter 1. Installing XUA
XYPRO Technology Corporation 16 Proprietary and Confidential
The AutoInstall script now checks the installed XTR version number against the
available version as shown below.
Verifying the system catalog can be written to ...
Verified the system catalog can be written to.
Verifications complete.
Unpaking products:
Unpaking XTRBIN ...
Unpak of XTRBIN complete.
Unpaking products complete.
Installing products:
If the installed software is older than the current version, the script will notify you and
perform the upgrade. Upgrading the XTR software requires licensing of one of the
installation programs to perform this function.
Comparing installed version of XTR to available version ...
A higher version of XTR was found.
XTR will be upgraded.
$VOL.P46DSDST.IADOPTN4 is not licensed.
Cannot continue until these files are licensed by SUPER.SUPER.
Please go to another TACL session, logon as SUPER.SUPER or an alias of
SUPER.SUPER, and license these files. You may continue when this has been done.
If you decide not to continue, the next time the wizard is run, the wizard
will continue where you last stopped.
To license these files, enter the following commands:
FUP LICENSE $VOL.P46DSDST.IADOPTN4
Are you ready to continue <Y/N>?
Do not answer the above prompt yet.
Start a separate TACL session using a SUPER.SUPER logon, and perform the
necessary licensing tasks as shown in the Example below.
Example:
TACL> FUP LICENSE $VOL.P46DSDST.IADOPTN4
TACL> Logoff as the SUPER.SUPER or SUPER alias
When you complete the licensing tasks, answer Y to the prompt below to continue.
Are you ready to continue <Y/N>? Y
Establishing product locations ...
Product locations established.
Performing verifications ...
Verifications complete.
Installing products: