XYGATE User Authentication Reference Manual

XYGATE
®
User Authentication
™
(XUA) 1.85 Reference Manual
Chapter 1. Installing XUA
XYPRO Technology Corporation 20 Proprietary and Confidential
Updating config ...
Config updated.
Product locations established.
Available version of XTR is not higher than the
installed version. XTR installation skipped.
Performing verifications ...
If the installed XUA software product version is the same or newer than the version
being installed by the script, the upgrade will be skipped as shown above.
The AutoInstall script now checks the installed XTR version number against the
available version as shown below.
Verifying the system catalog can be written to ...
Verified the system catalog can be written to.
Verifications complete.
Installing products:
If the installed software is older than the current version, the script will notify you and
perform the upgrade. Upgrading the XUA software requires licensing of one of the
installation programs to perform this function.
Comparing installed version of XUA to available version ...
A higher version of XUA was found.
XUA will be upgraded.
Installing XUA from \N1.$VOL.ZXYPROUA ...
Install of XUA complete.
Install of products complete.
XUA has not been finished via SUPER.SUPER.
Please go to another TACL session, logon as SUPER.SUPER or an alias of
SUPER.SUPER, and
RUN $VOL.XYGATEUA.XUA INSTALL
XUA_FINISH_INSTALL
You may continue when this has been done.
If you decide not to continue, the next time the wizard is run, it will
continue here, where you last stopped.
Are you ready to continue <Y/N>?
Do not answer the above prompt yet.
Start another TACL session using a SUPER.SUPER logon, and perform the licensing
tasks as directed by the script. The specific licensing instructions vary depending on
which products were installed or upgraded.