XYGATE User Authentication Reference Manual

XYGATE
®
User Authentication
™
(XUA) 1.85 Reference Manual
Chapter 1. Installing XUA
XYPRO Technology Corporation 22 Proprietary and Confidential
Note: The AutoInstall script waits on a prompt while the user starts a separate TACL
session when requested to perform specific actions. The user continues the
script after the action by responding to this prompt. However, if the user stops
the AutoInstall script for any reason, it must be restarted with the RUN
command as shown below. This will continue the upgrade from the point of exit.
Start the IWIZARD script.
Example:
TACL> RUN IWIZARD
Initializing config file ...
Done initializing config file.
Warning: Access to SUPER.SUPER (or an alias to SUPER.SUPER) may be required to
complete the installation of each XYGATE product.
During the installation, if the need for SUPER.SUPER arises, the
installation will be paused and the user will be asked to issue
specific commands from another TACL prompt while logged on as
SUPER.SUPER (or an alias to SUPER.SUPER), after which the
installation can continue.
If these commands cannot be issued by SUPER.SUPER (or an alias to
SUPER.SUPER) at the time of the initial installation, the user has
the option to stop the installation. The next time the user runs the
IWIZARD, the installation process will continue from the point where
it was stopped.
Are you ready to continue <Y/N>? Y
The AutoInstall script will attempt to locate any already installed XTR environments
and display these located environments as shown below.
Establishing product locations ...
-------------------------------------------------------------------------------
The XYGATE Transaction Router (XTR) is used to provide communication between
XYGATE GUI products and their HP NonStop server counterparts. The transaction
router provides the connection between the PC and the NonStop host via a
LISTNER.
One installation of XTR can be utilized by all the XYGATE GUI products, so you
only need to configure one port on each host even if you are using more than
one XYGATE GUI product.
Discovering XTR ($*.*) ...
Discovery complete.
SEL LOCATION VERSION OWNER AVAILABILITY
--- ----------------- ------- ----------------- ------------
1) $VOL.XYGATETR 1.55 XYPRO.JAMES Available
2) $VOL.XTR160 1.59 XYPRO.JAMES Available
4) $VOL.XYGATETR ROLE.SECMGR Not Available
P) Prompt for new location Available
Press BREAK or <CONTROL>-Y to exit.
Enter available selection: