XYGATE User Authentication Reference Manual

XYGATE
®
User Authentication
™
(XUA) 1.85 Reference Manual
Chapter 1. Installing XUA
XYPRO Technology Corporation 27 Proprietary and Confidential
1. Locate the installation subvolume where the XUA product AutoInstall script was
executed.
Syntax:
TACL> VOLUME <$NEWVOL>.ZXYPROUA
Example:
TACL> VOLUME $MYVOL.ZXYPROUA
2.
If the UNIWIZ script does not exist, use the following command to unpack the
software and make the script accessible:
TACL> OBEY IXYBIN
3.
Start the UNIWIZ script with the parameter Y.
Example:
TACL> RUN UNIWIZ Y
The UNIWIZ script requires the parameter Y to perform the uninstall. This
parameter is designed to stop inadvertent use of this tool. The script will display the
locations specified for XTR and XUA installations from the last time the IWIZARD
auto-install tool was run; otherwise, it will prompt for the installation locations to be
uninstalled.
Important! All files in the displayed locations will be purged. You will be prompted
to verify that this is correct and are therefore responsible to verify that this is
accurate before continuing. Failure to do so could inadvertently purge files possibly
belonging to a different product installation for which removal was not intended.
Examining environment ...
Done examining environment.
XYGATE XTR and XUA Products Uninstall
WARNING:
This will remove ALL files from the following locations, even if the
product was not recently installed or upgraded:
XTR Installed files on \N1.$VOL.XYGATETR
XUA Installed files on \N1.$VOL.XYGATEUA
Are you ready to continue <Y/N>?
If you wish to uninstall these XUA and XTR environments, enter Y to continue. The
uninstall process takes a few minutes to complete.
Are you ready to continue <Y/N>? Y
Working ...
Detaching segment ...
Removing XTR Installed files on \N1.$VOL.XYGATETR ...
Removing XUA Installed files on \N1.$VOL.XYGATEUA ...
Checking results ...
Done.