ZLE Adapter for ATMs, POS Reference Manual

©Opsol Integrators Inc. Page 11 of 12
528947-001
• Unable to get my process name.
Cause: Process name could not be obtained.
Action: Contact product support.
• Unable to get pathmon name, error <error name>.
Cause: Pathmon name could not be identified.
Action: Contact product support.
• Unable to post READX on DIST. No Sockets available.
Cause: Initial read on DIST failed.
Action: Check if the DIST process is available.
• Unable to find the parameter in pathway configuration.
Cause: The parameter is not specified correctly.
Action: Specify the parameter and try again.
• Parameter value out of range.
Cause: Value for the parameter is not specified correctly.
Action: Specify the correct value and try again.
• Assuming default value <value> for the parameter <parameter
name>.
Cause: Value for the parameter is not specified correctly.
Action: This is an informational message.
• Stop issued by <process name>.
Cause: Stop command issued by the process specified.
Action: This is an informational message.
• Stopping the Opsol ZLE adapter process
Cause: Stopping the process as the result of preceding error
condition.
Action: Informational message or correct the preceding error
condition and retry.
• DIST error <error> on AWAITIOX
Cause: Filesystem error returned while reading DIST process.
Action: Correct the filesystem error and try again.
• Unable to send message to ZGATE, Pathmon err <path error>,
file err <file error>.
Cause: Error occurred while sending message to the Gateway
process.
Action: Correct the error conditions and try again.