HP Officejet Pro X series - Printbar Install Guide

4
13 14

1
2
Install the printbar safety cap on the printbar to protect the ink
nozzles. Install the two front rubber bumpers (callout 1) into
the matching notches in the printbar, then rotate the printbar
safety cap back and up to engage the catches on the back of the
printbar (callout 2).
Install the printbar dolly.
Locate the service sled guides (callout 1).
15 16

Place the dolly (callout 1) on the guides.
Push the dolly into the product until it reaches the left side, and
then lower the printbar by hand onto the seated dolly. This will
prevent the printbar from inadvertently dropping onto the dolly.
You may now remove the printbar lock tool.
17 18



X476/X576 models only: Disconnect the eject ap opto ex
cable connection (callout 1), and then unthread the cable (callout
2) from the product frame.
X476/X576 models only: Remove nine screws (callout 1) from
the top cap.