HP Officejet Pro X series - Printbar Install Guide

5
19 20
21





X451/X551 models only: Remove ve screws (callout 1), and
then remove the brace (callout 2).
Disconnect three printbar ex cables (callout 1).
22

Unthread the three ex cables through the ferrite holder
(callout 1).
REINSTALLATION TIP: When reinstalling, remember to
thread the two white ex cables through the ferrites correctly.
(The black ex cable goes through a slot in the plastic holder.)
Doing so ensures that the product meets regulatory standards.
REINSTALLATION TIP: When reinstalling, inspect the printbar
ex cables for damage. If any damage exists, replace the
damaged cable.
REINSTALLATION TIP: Manually clasp the cables to make sure
that the ZIF sockets are closed on the cables correctly.
X476/X576 models only: Lift the top cap assembly up to remove
it from the product.