HP Officejet Pro X series - Printbar Install Guide

6
25 26

Locate both lift guides (callout 1) on the top left of the product.
Pull each lift guide up to remove.
CAUTION: The lift guides are greasy.
REINSTALLATION TIP: Lift guide rods must be replaced in the
same position. For example, front guide back into the front of
the product. If the printbar lift rod Z stop is broken, it must be
replaced (part CN598-67048). If you are installing a new Z-stop,
the top of the lift guide rods will stand above the top of the case.
Installing the top cap assembly will cause the Z stop to crush
down to the correct height.
24
Unthread all three of the printbar cables through the front frame
of the product.
23

Carefully use a screwdriver to remove the ex cable retainer
(callout 1) from the product. Take care to avoid damaging
the cable.