HP OneView 1.0 User Guide

Table 15 Development networks
VLAN IDName
1105dev 1105
1106dev 1106
1107dev 1107
1108dev 1108
Table 16 Test networks
VLAN IDName
1111test 1111
1112test 1112
1113test 1113
1114test 1114
Table 17 Ethernet network configuration values
NotesValueConfiguration attribute
EthernetType
This is the default value displayed on the Create network screen.2.5 Gb/sPreferred bandwidth
This is the default value displayed on the Create network screen.10 Gb/sMaximum bandwidth
This is the default value displayed on the Create network screen.SelectedSmart link
This is the default value displayed on the Create network screen.Not selectedPrivate network
A.3 Planning the configuration
A.3.1 Planning for installation of the appliance
For the sample data center, assume that you make the following choices before and during
installation:
• You follow the recommendations in the HP OneView Installation Guide, including:
Choosing a physical host for the appliance virtual machine (VM) that is not targeted to
be managed by this appliance
◦
◦ Choosing a static IP address
◦ Ensuring that the ports required by the appliance are available
• You allow support personnel to access the appliance.
• You synchronize the appliance time with the VM host time.
• When prompted to change the Administrator password, you use the password SDC14u$.
• You specify the following for the appliance networking settings:
ValueConfiguration attribute
myhostname.example.comAppliance host name
ManualIPv4 address assignment
255.255.240.0Subnet mask
236 Step by step: Configuring an example data center using HP OneView