HP OneView Deployment and Management Guide 1.05
Technical white paper | HP OneView Deployment and Management Guide
5
Supported Servers
• All HP ProLiant Gen8 BL-family of servers
• All HP ProLiant Gen8 DL-family of servers
• BL460/465 G7
• BL490 G7
• BL685 G7
• BL680 G7
Supported IO Adapters
• All HP Flex-10 and FlexFabric 10Gb adapters
• BladeSystem HBA’s are allowed, but will be unmanaged and must be connected to non-Virtual Connect FC modules.
Supported Interconnects
• HP Virtual Connect FlexFabric 10Gb/24-Port Module
• HP Virtual Connect Flex-10 10Gb Ethernet Module
• HP Virtual Connect Flex-10/10D Ethernet Module
Hardware Firmware Minimum Requirements
Table 3 shows the minimum firmware requirements needed to successfully import an enclosure. Firmware will be updated
via the appliance to the required versions later in this document.
Table 3. Minimum Firmware Requirements
Onboard Administrator
3.00 or newer
iLO4
1.01 or newer
iLO3
1.20 or newer
Virtual Connect
3.15 or newer
Table 4. Post Import Firmware Minimum Version
Onboard Administrator
4.01
iLO4
1.30
iLO3
1.61
Virtual Connect
4.10
Note
The Appliance Virtual Machine should not be deployed on a hypervisor within the same enclosure it will manage. Please use
an externally available hypervisor host.
Table 5 shows the HP OneView 1.0 and 1.05 Configuration Maximums.
Table 5. Supported Maximums
Total Servers
640
Servers per Enclosure
16
Total Enclosures
40