OpenView Storage Provisioner v1.1 - Release Notes

Storage Provisioner Issues
12 OpenView Storage Provisioner Release Notes
Note: If the host is physically connected to the utility but cannot see the volumes, check
your zoning setup. See the
SAN Design Reference Guide for zoning information, at:
http://h18006 .www1.hp.com/products/storageworks/san/documentation.html .
Using the default disk group (HSV-based storage systems)
A default disk group for HSV-based storage systems is created during
initialization of the storage system. To optimize Storage Provisioner with
HSV-based storage systems:
■ Leave the default disk group as the only disk group to allow for maximum
flexibility.
■ Double the default disk group disk failure protection level to allow for
maximum safety.
If your HSV-based storage systems are already set up and configured with
other disk groups, Storage Provisioner will use all of them. Additionally,
Storage Provisioner will add any ungrouped disks to disk groups as needed
when completing a provisioning request.
Running Storage Provisioner from the SMA console
Storage Provisioner is configured to run from a a client workstation.
Consequently, if you try to run Storage Provisioner using the browser on the
console of your SMA, you will see the following error:
Figure 1: Error message
To run Storage Provisioner from the SMA console:
1. Start your browser from the SMA console.