HP MSA Contoller Module Installation Instructions (590339-005, June 2013)
HP MSA Controller Module
Installation Instructions
Abstract
This document details procedures for installing a controller
module in HP MSA enclosures.
© Copyright 2009, 2013 Hewlett-Packard Development Company, L.P.
Printed in the US.
*590339-005*
HP Part Number: 590339-005
Published: June 2013
Edition: 5
About this document
• The Storage Management Utility (SMU) and the
Command Line Interface (CLI) can be used to
manage the enclosure. Tasks in this document
demonstrate using the SMU.
• For the latest product documentation, see the HP
website at http://www.hp.com/support/manuals.
Under the storage banner, navigate to the page
for your storage enclosure.
Before you begin
Observe the following:
CAUTION:
• Removing a module from an operational
enclosure significantly changes air flow
within the enclosure. Openings must be
populated for the enclosure to cool
properly. Leave modules in the enclosure
until a replacement is available.
• Parts can be damaged by electrostatic
discharge; use proper anti-static protection.
Keep parts in electrostatic containers until
needed and ensure you are properly
grounded when touching static-sensitive
components.
IMPORTANT: When two controllers are
installed in an enclosure, they must be the same
model. Mixing controller types in the same
enclosure is not supported.
NOTE: To reduce impact on system
performance, perform all maintenance tasks
during periods of low system activity or during
a system maintenance window.
Page 1