HP StoreVirtual 4630 Storage Maintenance Guide (AX696-96343, December 2013)

3. Select Ignore enclosure serial number in restored configuration file to restore a configuration
that was generated on another enclosure. If this item is not selected, a configuration generated
on another enclosure is rejected.
4. Select Ignore firmware version in restored configuration file.
5. Click Restore Configuration.
6. Confirm the domain configuration to be restored, and then click OK.
Backing up the SAS switch
The SAS switch configuration cannot be backed up using the CMC. If you are replacing one SAS
switch, duplicate the configuration from the other switch. If you are replacing both SAS switches,
you must restore the configuration from a backup captured using the VSM CLI. For information
about backing up and restoring the SAS configuration using the VSM CLI, see the HP Virtual SAS
Manager User Guide.
IMPORTANT: HP recommends that you do not change the SAS zoning on the SAS switches or
the cabling between the SAS switches and the disk enclosures. See “HP 4630 system cabling”
(page 35) for the recommended cabling.
Backing up remaining HP 4630 system configurations
Use one of the following methods to back up the remaining HP 4630 system configurations:
• Use your own system backup utility to back up data.
• Back up the configuration to an FTP server.
12 Backing up HP 4630 system configurations