11.0 HP StoreVirtual Storage VSA Installation and Configuration Guide (TA688-96141, September 2013)
1. Begin the installer one of the following ways:
• Unzip the files if you downloaded a .zip file, and then double-click the executable to start
the installation.
• Double-click the downloaded executable to start the installation.
• If you downloaded the HP StoreVirtual VSA Software .iso image, either mount the .iso to
a virtual drive, or use a DVD created from the .iso image, and navigate to autorun.exe.
2. Accept the terms of the License Agreement.
3. Configure the parameters of the virtual machine on the network, including the hard drives.
See Table 6 (page 19).
NOTE: You can run the wizard again to configure another VSA for Hyper-V using the same
parameters as appropriate.
4. Finish the installation, reviewing the configuration summary.
When the installer is finished, the VSA for Hyper-V is ready to be used in HP StoreVirtual
Storage.
5. Next, install the CMC, described in “Getting started with HP StoreVirtual Storage” (page 21).
Then follow the steps in “Installing the CMC” (page 21).
The installer may take a few minutes to complete, depending upon the underlying hardware.
Troubleshooting the VSA for Hyper-V
Table 7 Troubleshooting the VSA for Hyper-V
SolutionProblem
While installing the VSA for Hyper-V, you do not see the
physical disks you prepared.
1. Close the installer.
2. Verify that the disks are offline.
3. Start the installer again.
Do not use an iSCSI volume on a SAN as the physical disk
for a StoreVirtual VSA.
VSA for Hyper-V reboot fails if the physical disk of the VSA
for Hyper-V is an iSCSI mounted volume
Using the Hyper-V Manager:You want to reinstall the VSA for Hyper-V.
1. Close your CMC session.
2. In the Hyper-V Manager, power off the VSA for Hyper-V.
3. Right-click and select Delete from Disk.
4. Optional: Delete the .vhd files to recover the disk
space.
5. Rerun the .exe file and reinstall the VSA for Hyper-V.
6. Open the Hyper-V Manager and begin again.
Open the Configuration Interface. Navigate to the Network
Settings window to verify the IP address.
You cannot find the VSA for Hyper-V with the CMC, and
cannot recall its IP address.
20 Installing the HP StoreVirtual VSA for Microsoft Hyper-V