9.5.01 HP P4000 SAN Solution User Guide (AX696-96168, February 2012)

Figure 76 SysAdm cluster now has the SmartClone volumes, clone point, and the source volume
Table 52 (page 185) shows the shared and individual characteristics of SmartClone volumes. Note
that if you change the cluster or the data protection level of one SmartClone volume, the cluster
and data protection level of all the related volumes and snapshots will change.
Table 52 Characteristics of SmartClone volumes
Individual characteristicsShared characteristics
NameCluster
DescriptionData protection level
Size
Type (Primary or Remote)
Provisioning (Thin or Full)
Server
NOTE: Snapshot schedules and remote copy schedules are also individual to a single SmartClone
volume.
Clone point
The icon shown here represents the clone point in the navigation window. The clone point is the
snapshot from which the SmartClone volumes are created. The clone point contains the snapshot
data that is shared among the multiple volumes. Because the SmartClone volumes and their snapshots
depend on the clone point, it cannot be deleted until it is no longer a clone point. A clone point
ceases to be a clone point when only one SmartClone volume remains that was created from that
Clone point 185