9.5 HP P4000 VSA Installation and Configuration Guide

Figure 2 Configuring the hardware
1. Configure RAID and the TCP/IP network from these categories
Configuring RAID
Configure RAID after powering on the VSA. If you power off the VSA and add disks, you must
re-configure RAID when you power on the VSA.
RAID and the VSA for Hyper-V Server
If you create the VSA for Hyper-V Server with one disk, RAID will be automatically configured. If
you create the VSA for Hyper-V Server with more than one disk, you must manually add the
remaining disks to RAID using the CMC.
1. Select the system in the Available Systems pool.
2. Navigate to the Storage category.
3. Use either of the following methods to add the remaining disks to RAID.
• On the RAID Setup tab, click RAID Setup Tasks and select Reconfigure RAID.
• On the Disk Setup tab, click Disk Setup Tasks and select Add Disks to RAID.
Getting started with the CMC 15