11.0 HP StoreVirtual LeftHand OS Command Line Interface User Guide (AX696-96291, September 2013)

DescriptionName
The CHAP name for the volume. If this is not specified, the IQN of the local
server is used (this parameter is required if run on a storage system).
[chapName]
The CHAP initiator secret for the volume.[initiatorSecret]
Enter the IP address of the client server that has Application Aware Snapshot
Manager (AASM) installed on it. It will coordinate the snapshot with the
[controllingserver]
applications using SAN volumes. This is required for managed snapshots of
Fibre Channel connected volumes. This is also required for VMware managed
snapshots, enter the Virtual Center Server IP address.
Allow Fibre Channel ports to be assigned to the client. Values are 0—Disable
and 1—Enable. If volumes are attached to a client server via Fibre Channel
[allowfcaccess]
and a value of 0 is entered, the client will lose its ability to communicate with
the attached volumes.
A semicolon delimited list of the unique World Wide Port Name for one or
more Fibre Channel ports. Expected WWPN formatting is 16 Hex characters
[wwpn]
with or without the : character as a delimiter (for example,
20:21:00:0E:B3:01:AB:C6 or 2021000EB301ABC6). Lower case hex
characters a–f are also accepted.
The LUN (1–255) of the boot volume. Valid only for a Fibre Channel attached
volume. If present, then bootvolumename must also be specified.
NOTE: LUN 255 is not supported by Microsoft Windows.
[bootvolumelun]
The volume name of the boot volume. Valid only for a Fibre Channel attached
volume. If present, then bootvolumelun must also be specified.
[bootvolumename]
Example 45 Windows
cliq createServer serverName=TheServer useCHAP=0
initiator=iqn.1991-05.com.microsoft:w-gregorio.corp.mynetworks.com
login=10.0.1.2 userName=admin passWord=secret
Example 46 SSH
createServer serverName=TheServer useCHAP=0
initiator=iqn.1991-05.com.microsoft:w-gregorio.corp.myworks.com
createSite
Description
Create a site in a multi-site SAN.
Syntax
createSite {login=} { userName= passWord= | groupName= } {siteName=}
[description=] [primary=] [node=]
Parameters
DescriptionName
The IP addresses or DNS-resolvable names of one or more storage systems.{login}
The authentication user name for the storage system. If you use this parameter,
you must include the passWord parameter with it. Or, you can use the
groupName parameter instead of userName and passWord.
{userName}
34 Commands