10.5 HP StoreVirtual Storage User Guide (AX696-96269, March 2013)

Using the Failover Manager for VMware vSphere
Install the Failover Manager from the DVD, or from the DVD .iso image downloaded from the
website:
http://www.hp.com/go/StoreVirtualDownloads
The installer offers two choices for installing the Failover Manager for VMware:
Failover Manager for VMware vSphere—The installer for the Failover Manager for VMware
vSphere includes a wizard that guides you through configuring the virtual machine on the
network and powering on the Failover Manager.
Failover Manager for other VMware platforms—The installer for the Failover Manager for
other VMware platforms includes a wizard that installs the Failover Manager. Then you find
the Failover Manager, boot the system, and configure it for the HP StoreVirtual Storage network.
CAUTION: Do not install the Failover Manager on a volume served by the HP StoreVirtual Storage,
since this would defeat the purpose of the Failover Manager.
Minimum system requirements for using the Failover Manager with VMware vSphere
Server version 4.x or later
Microsoft .Net 2.0 or later on the installer client
1024 MB of RAM
Bridged connection through the VMware Console, or assigned network in VI Client
15 GB of disk space
Installing the Failover Manager for VMware vSphere
1. Insert the DVD in the DVD drive (either the physical HP StoreVirtual VSA and Failover Manager
DVD you received or the DVD you created after downloading the DVD .iso image from the
web).
2. Locate the applicable executable and double-click it to begin.
3. Click Agree to accept the terms of the License Agreement.
4. Click Install FOM for VMware vSphere to begin the wizard.
5. In the Meta Launcher command line window that opens, enter 1 to run the installer CLI, or
enter 2 to run the installer GUI. Both versions require the same information and perform the
same installation.
NOTE: If you selected the GUI installation in the Meta Launcher CLI window, the GUI installer
window opens again. Click Install FOM for VMware vSphere again to begin the wizard.
6. Click Next on the Welcome page of the wizard.
7. Click I accept the terms of the License Agreement and click Next.
8. Enter the IP address or hostname, and the login credentials for the ESX or vCenter Server that
will host the Failover Manager, and click Next.
9. Select the ESX or vCenter Server host, verify the health status and configuration details, and
click Next.
10. Select Failover Manager as the type of installation and click Next.
11. Select a datastore, not on the SAN, to store the virtual appliance files, and click Next.
12. Enter a name for the Failover Manager and enter the IP address or choose to use DHCP. Select
the network interface to use and add multiple NICs if desired. Click Next.
13. Enter a name for the virtual machine, and whether to use VMDK or raw disk mapping, and
click Next.
Using the Failover Manager 127