10.5 HP StoreVirtual Storage User Guide (AX696-96269, March 2013)

Table 22 Link aggregation dynamic mode failover scenario and corresponding NIC status
NIC statusExample failover scenario
1. Link Aggregation Dynamic Mode bond0 is created.
Interface:Port1 and Interface:Port2 are both active.
• Bond0 is the master logical interface.
• Interface:Port1 is Active.
• Interface:Port2 is Active.
2. Interface:Port1 interface fails. Because Link Aggregation
Dynamic Mode is configured, Interface:Port2 continues
operating.
• Interface:Port1 status becomes Passive (Failed).
• Interface:Port2 status remains Active.
3. Interface:Port1 link failure is repaired.
• Interface:Port1 resumes Active status.
• Interface:Port2 remains Active.
Summary of NIC states during failover
Table 23 (page 63) shows the states of Interface:Port1 and Interface:Port2 when configured for
Link Aggregation Dynamic Mode.
Table 23 NIC status during failover with link aggregation dynamic mode
Status of Interface :Port2Status of Interface :Port1Failover status
Preferred: NoPreferred: NoNormal Operation
Status: ActiveStatus: Active
Data Transfer: YesData Transfer: Yes
Preferred: NoPreferred: NoInterface:Port1 Fails, Data Transfer
Fails Over to Interface:Port2
Status: ActiveStatus: Passive (Failed)
Data Transfer: YesData Transfer: No
Preferred: NoPreferred: NoInterface:Port1 Restored
Status: ActiveStatus: Active
Data Transfer: YesData Transfer: Yes
Example network cabling topologies with link aggregation dynamic mode
A simple network configuration using Link Aggregation Dynamic Mode in a high-availability
environment is illustrated in Figure 34 (page 64).
Configuring network interface bonds 63