HP Controller Enclosure Battery Replacement Instructions (5697-1348, June 2012)

ManualsBrandsHP ManualsStorageHP P6300 EVA Dual FC/10GbE Cntlr w/LFF Encl&Cmd View Combo Factory Integrate Kit

HP Controller Enclosure

Battery Replacement

Instructions

Printed in Puerto Rico

*5697-1348*

HP Part Number: 5697-1348

Published: June 2012

Edition: 2

About this document

For the latest documentation, go to http://

www.hp.com/support/manuals, and select your

product.

The information contained herein is subject to change

without notice. The only warranties for HP products

and services are set forth in the express warranty

statements accompanying such products and services.

Nothing herein should be construed as constituting an

additional warranty. HP shall not be liable for technical

or editorial errors or omissions contained herein.

WARRANTY STATEMENT:

To obtain a copy of the warranty for this product, see

the warranty information website:

http://www.hp.com/go/storagewarranty

Before you begin

XCS version 11001000 and later supports HP

P6350/P6550 EVAs with 2- or 4-GB DIMMs and large

capacity batteries. Upgrade kits are available that

include batteries, DIMMs, and an ABM. If you are

upgrading an HP P6300 to P6350 or an HP P6500

to P6550, HP recommends that you install an upgrade

kit. Because you must install the upgrade components

in a specific order and off line, follow the procedure

in HP P6000 EVA Upgrade Instructions — P6300 to

P6350 or P6500 to P6550.

There are three battery models. The battery module

faceplate identifies the model.

• A P6300 or P6500 EVA can use AG637-63601,

QK715-63601, or QK717-63601 batteries.

• A P6350 EVA can use QK715-63601 or

QK717-63601 batteries.

• A P6550 EVA can use QK717-63601 batteries

only.

Observe the following precautions when replacing the

battery module.

CAUTION: Removing a battery module

significantly changes the air flow within the

enclosure. Both modules must be installed for

the enclosure to cool properly. If a single battery

module fails, leave it in place in the enclosure

until a new module is available to install.

Page 1

Summary of content (3 pages)

PAGE 1
HP Controller Enclosure Battery Replacement Instructions About this document For the latest documentation, go to http:// www.hp.com/support/manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty.
PAGE 2
• Port-colored (purple) handles on components like the battery module means the component is hot-swappable and can be replaced without having to power the system down. • There are two battery modules under the bezel on the front of the controller enclosure. See Figure 1 (page 2) for the locations. Each battery provides power to the controller directly across from it in the enclosure. Battery 1 (B1) provides power to controller 2 (C2) and battery 2 (B2) provides power to controller 1 (C1).
PAGE 3
4. Position one hand under the battery module, and with the other hand, pull the battery out of the enclosure. Figure 3 Removing a battery module Installing a battery module 1. 2. 3. Insert the battery module into the enclosure. Push the battery module into the enclosure until a click is detected when fully seated. Attach the bezel.