HP Controller Enclosure Midplane Replacement Instructions (593095-001, June 2011)

6. Remove the two power supply modules.
a. Move the mounting latch to the left (1, Figure 4), grasp the
handle, and pull the power supply out slightly.
b. Position one hand under the power supply, and with the other
hand, pull the power supply out of the enclosure (2, Figure 4).
Figure 4 Removing a power supply
.
7. Remove the two controllers.
a. Move the mounting latch to the right (1, Figure 5). The controller
will slightly eject from the enclosure.
b. Position one hand under the controller, and with the other hand,
pull the controller out of the enclosure (2, Figure 5).
Figure 5 Removing a controller
.
8. Remove the management module.
a. Lift the latch up on the module (1, Figure 6) and pull the module
out slightly.
b. Position one hand under the module, and with the other hand,
pull the module out of the controller enclosure (2, Figure 6).
Figure 6 Removing a management module
.
9. Remove the top access cover.
a. Loosen the cover thumbscrew (1, Figure 7).
b. Slide the access panel out and off (2, Figure 7).
Figure 7 Removing top access cover
.
Page 3