HP P6300/P6500 EVA Fibre Channel Controller Enclosure Replacement Instructions (5697-2515, March 2013)

Figure 4 Removing the controller cover
5. See Figure 5 (page 4) for the location of the two
DIMMs on the controller.
Figure 5 Location of controller DIMMs
2. Slot 2 (cache memory)1. Slot 1 (policy memory)
6. Press the retaining clips outward to unlock each
DIMM socket (1, Figure 6 (page 4)).
The modules release, and partially lift out of the
socket.
Figure 6 Removing a DIMM
7. Remove each DIMM (2).
Installing a controller
1. Press each DIMM from the removed controller into
the same DIMM socket on the replacement
controller (1, Figure 7 (page 4)).
Figure 7 Installing a DIMM
2. Press the retaining clips inward to lock each
DIMM into the socket (2).
3. Place the cover on the controller module rails and
slide the cover over the controller until the latch
clicks into place.
Figure 8 Installing the controller cover
4. Move the small form-factor pluggable (SFP)
modules, installed in the unused FC host ports,
from the controller being replaced to the new
controller (if there are unused FC ports).
Page 4