HP P6300/P6500 EVA Fibre Channel Controller Enclosure Replacement Instructions (5697-2515, March 2013)

5. Reinstall the controller.
a. Push the controller halfway into the controller
enclosure (1, Figure 9 (page 5)).
b. Connect the SAS device port cables to the
controller device ports.
NOTE: Inserting a controller without
connecting the device port cables can
result in soft diagnostic errors.
c. Fully insert the controller. Move the mounting
latch to the left until fully engaged and the
controller is fully seated in the enclosure (2).
The controller should power up automatically.
Tighten the controller latch thumbscrew.
Figure 9 Installing a controller
d. Reinstall the FC host cables and any
disconnected Ethernet or console cables.
Verifying operation
After replacing the controller, observe the following
to verify the component is operating properly:
NOTE: Wait approximately 3 minutes for the
system to check the component status.
• Verify the controller health green LED is lit (see
Table 1 (page 3)). If not, try reseating the
controller in the enclosure.
• From HP P6000 Command View, navigate to the
component as described in the Verifying
component failure section, and verify that the
status is (Good).
Documentation feedback
HP is committed to providing documentation that meets
your needs. To help us improve the documentation,
send any errors, suggestions, or comments to
Documentation Feedback ([e-mail]).
Include the document title and part number, version
number, or the URL when submitting your feedback.
Page 5